+1 604 245 8181 Get a Free Quote
Two workers in hi-vis vests shot-blasting an underground parkade deck, a blue dust collector connected to the machine by hose

Built to Protect. Engineered to Last.

Traffic coating, waterproofing, and concrete protection for parkades, decks, and structural surfaces across British Columbia — specified to the surface, the traffic, and the weather it has to survive.

Get a Free Quote View Our Projects
An underground parkade deck with parallel pass marks from shot-blasting, the blue dust collector at the right

Specified, Not Just Applied

About BC Traffic Coating

BC Traffic Coating installs coating and waterproofing systems on parkades, decks, and structural concrete across British Columbia. Our certified applicators work to manufacturer specification — surface preparation, film thickness, and cure times held to the numbers the system was tested at, because those numbers are what decide whether it lasts.

A multi-level parkade, a residential balcony, and an exposed structural slab each fail in a different way. We assess the substrate, the traffic it carries, and the water it has to shed, then specify a system matched to those conditions instead of applying the same build to every surface.

  • Systems Matched to the Surface
  • Continuous at Every Detail
  • Slip-Resistant Where It Matters
  • Built for Coastal BC Weather

What We Do

Our Specialties

From high-traffic parkades to exposed rooftop decks, every surface gets a system chosen for its substrate, its load, and the water it has to shed.

A concrete deck being mechanically ground back to sound substrate, grinder and vacuum hose in frame
Preparation
The old membrane stripped back at the parkade entrance, ready for the new system
Application
The finished entrance deck under a continuous grey membrane, sealed to the drain and up every edge
Completed

One job, start to finish

The same doorway photographed at three stages of the same job. Most of what decides whether a coating lasts happens before any membrane goes down, so the preparation is shown here too, not just the result.

View more projects

How We Work

Our Process

  1. 01

    Grind & Prepare

    The slab is mechanically ground to remove laitance and open the surface profile, so the system bonds to sound concrete rather than to contamination.

  2. 02

    Apply the System

    Membrane and base coats are laid down wet-on-wet at the specified thickness, carried up the perimeter to form a continuous, sealed surface.

  3. 03

    Finish & Cure

    The wear coat is finished to a uniform, slip-resistant surface and cured before traffic returns — sealed at the drain and along every edge.

Peace of Mind

Certified Applicators

Measured, Not Guessed

Details Where Coatings Fail

Manufacturer-Spec Materials

Checked at Every Stage

Priced to the Scope

Get started

Request Your Free Quote

How It Works

  1. Tell us who you are and how to reach you.
  2. Pick the service your surface needs, if you know it.
  3. Add square footage and location if you know them, then send it over.

Fields marked * are required.

+1

Service needed (optional)

Choose one or more options.

Call Now Get a Free Quote